I’m considering an a change at point as well. The v2 has been great but finicky is a perfect description. Any reason you were thinking Bambo Labs instead of a Prusa?
I’m considering an a change at point as well. The v2 has been great but finicky is a perfect description. Any reason you were thinking Bambo Labs instead of a Prusa?
Of course! This should be the original link. I think my issue was slightly different, but hopefully this helps. My stepper motors were over heating and skipping steps. If it looks like that might solve your issue, this article helped with my ender 3
Thank you! I appreciate it!
Thank you, i’ll do some digging!
Oh man, you should have seen me looking for the HDMI ports. I was very confused until I realized my mistake. Turns out that there’s more than one kind, who knew🤷
I’ll have to give that camera connection a second look lol
Damn does this mean I have to buy another raspberry pi or can the one running octoprint serve double duty?
I just picked up a pi4 b today and was tinkering with octoprint.
So far it looks great, i just haven’t figured out how to get the pi camera module 3 working quite yet. The stream from octoprint just constantly tries to load.
I’m excited to try some prints with it soon!
No, that’s a new one.
Would greasing my gantry screw help?
If I’m missing steps due to heat is the only solution a new motherboard?
I thought so too! I cleaned it up a bit and glued the bottom back on. Its my pencil cup at work now
I have! This printer actually finished a 3ft sailboat rudder before this print. I popped some pictures of it in as well
Do you think that could be be solved by adjusting the z offset?
Thanks for the tip! I’ve been hesitant to start messing around to much but I think it should if it means it’s more reliable
I’ve been looking at this for a while. The camera I have on it is a security camera that i put on my desk while it prints if I’m gone.
Do you think its worth pulling the trigger on a raspberry pie to get this set up?
It would at least once lol
Yes, I just finished printing a rudder core for my sailboat.
For all the headache its caused, its also saved me from several trips to the store to find cable ties, chip clips, a hair dryer holder, pencil cups, spice racks, etc.
Sweet thank you!
How’s Freecad these days? I avoided awhile ago it because it looked difficult to use but I think this might push me over to it
This right here is the only thing I’m worried about
They sound like the Endermen from Minecraft
I have a Espon ET-5150. Its worked fine so far but I wish my wife would’ve let me spring for a laser printer.
Does he still work there?