.05 on my ender 3 s1 sounds perfect based on the tolerance tests I’ve run. Thanks!
.05 on my ender 3 s1 sounds perfect based on the tolerance tests I’ve run. Thanks!
Thats a very fair point. I’ve done tolerance tests with mine and can get away with 0 with some encouragement and .05 just fine. Thanks!
Just curious, when making this how much tolerance did you account for? I want to make some for baseball teams, but wasn’t sure how much to add.
Shouldnt be the filament then. I would make sure the probe is fully secured like the other comment suggested. Good luck, that sounds frustrating! I need to adjust mine, but usually after printing for a couple weeks.
What type of material are you printing? Could be the material is eating away at the brass nozzle causing you to need to adjust the z offset.
Well so much for that thought: [Bob Nightengale] Stephen Strasburg will continue be paid $35 million annually through 2026 (with about $11.4M deferred each year). He then will receive $26.6M in 2027, 2028 and 2029 in his owed deferred payments. The contract was not insured, leaving the #Nats on the hook for its entirety.
That is a lot of money to leave on the table - I wonder if he worked something out with the Nats for a buyout. If not, this is great for the future of the Nats. Opens up a significant amount of cash the next few years.
What a horrible last month or so for Angels fans. Struggle after a trade deadline where you were buyers instead of getting something in return for Ohtani. Ohtani has a rough month where he ultimately has a torn UCL. Trout goes back on the IL this night as well. Who knows what the team looks like next season. Sorry Angels bros!
I had a similar issue when I initially installed Klipper on my Ender 3 S1 (not the plus). It would not connect unless I fully restarted Octoprint whenever I turned on the printer. The change I needed to make was go into settings in Octoprint (though I assume its similar on other front ends), and add the following settings:
Serial Port: /tmp/printer
Baud Rate: 11520
If that is not the case for you, try to add some more details. Do you have the config file correct?