Brooke of the Straw Hat pirates
Brooke of the Straw Hat pirates
Lol, weird.
If you do end up getting a MacBook and want to run Linux on bare metal, you might want to get a slightly older one that has an Intel chip. Running Linux on Apple silicon is a slightly more involved process.
deleted by creator
deleted by creator
deleted by creator
So fucking sad
StandardNotes for me
The fact that prisons have stocks…
Gotcha, thanks so much for the reply. I was looking at EcoFlow options and the price range is also in the range I was looking at (a bit more with panels most likely). The EcoFlow options provide AC out right, so I would still need an inverter before plugging a UPS into it? Glad I asked.
I’ve had this before as well; Very annoying.
I try to balance things between what I find enjoyable/ worth the effort, and what ends up becoming more of a recurring headache
Lot of trolls lately
I’ve seen videos that show having two touch enabled cards next to each other prevents anyone from scanning, since their signals cause interference with one another.
I came across the video when looking up those RFID blocking cards you can add to a non shielded wallet and they work the same way
It’s a case for a Meshtastic node :) super fun project
Thank you, and no worries on the late reply. I’ll check all of this soon. You are right in there being a small gap there. It is normally tight, however I did loosen it a smidge because someone in a video mentioned that might add some forgiveness if one of the screws (or leadscrews as I’m learning) is not true.
Those screws are/ were dry though. I recently put a small amount of WD-40 onto a paper towel and cleaned them up a bit (maybe not the best choice vs a machine oil or something similar).
Thanks, I’ll give it some proper TLC soon and clean/ lube everything.
Thanks so much for all the pointers! 1, 3, 4 I will give them a try. I’ll have to see how to disconnect the threaded rod from the motor so that I can roll it on a surface (I’ve done similar with arrows in the past).
For 2, the top is open, nothing was modified. This printer was bought used years ago (maybe 4-5 years ago) and used to print perfectly. It was not used for the last 3 or so, and has gone through several moves. When we unboxed it again, there were a few broken parts that we had to reprint (the upper stabilizers that go around the support rod and threaded rod, and the y axis motor mount in the back). So it’s not inconceivable to think one or both of the rods could have been bent as well.
This happened to me as well. I’d take a few bites of a meal and feel full/ nauseous; Sometimes even throw up. It went away after maybe 6 months of dating and we joke about it now 12 years later.
We chalked it up to nerves, but no one can tell for sure. Best of luck OP! Guessing you really like this person.